This is usually a very simple fix. Just replace the inlet Seal that lives under the tank in the receptacle that the tank plugs in to. It’s also a good idea to clean the little filter as well.

You can purchase the jura inlet seal here.

Jura Parts here

  1. Remove the top cap. Some times best achieved by lying the machine on it’s side. Note in most models the side panel must be removed.

  2. Remove the old gasket and give the filter a clean.
  3. Install the new gasket and replace the top cover.
  4. Test with some water in the tank and make sure all is ok.
Firstly remove the cap. But don’t do it like this.
Lie the machine on its side to get at the tabs that hold the Gasket Cover on. Side panel has been removed.
The new Red Seal is fitted.

Trackbacks & Pings

Leave a Reply

%d bloggers like this: