BREVILLE CREATISTA Model: BNE800BSS – WAND ISSUE SOLVED
Do you have an issue similar to the one in the video below;
I have some good and bad news for you. The issue can be resolved but getting into these machines is difficult and the part expensive. I know that’s all just bad news but the good news is I can sell you the part.
So the issue is cause by a pressure sensor mounted on the main board. Or the chip that drives the sensor. We as of yet can not get just the sensor and chip so a complete board replacement is required. You can find that here…
Other errors may display but all are related to an incorrect steam pressure reading. Make sure your wand tip is not blocked before you go and purchase a new board.
Next time my tech does this job I’ll film him so you can have some idea how to get into this machine.
pressure sensor and drive chip
Previous Post
Next Post
Hello, I would like to purchase this motherboard. Do you ship to the US? How much is it? The issue with mine is that the black tip that connects to the hose comes off the motherboard and it gets wet. This makes the machine make weird sounds while off but plugged in. Thank you!
Hi can I buy this board I’ve found the same fault, same model BNE800BSS, apparently a common fault on this model, the pipe had detached from the switch also, spraying water damaging the board.Display works fine though.
Honeywell NBPDANN150PGUNV or TBPDANN150PGUCV looks like they might be the sensor
or NBPDANN150PAUNV
TBPDANS150PGUCV (with silicon gel) seems a better replacement
In fact, I believe it should be TBPDANS060PGUCV.
Reasons:
1-TBP doesn’t require calibration.
2-D AN for axial barbed
3-S for silicon gel (exposed to moisture)
4-060PG for vented gauge 60 psi steam pressure, rather than 150 psi brew/pump pressure
5- UCV for unamplified